Silicone Rubber Right Products Having problems printing?
SPECIALISTS IN SILICONE RUBBER SINCE 1952
www.siliconerubber.com           info@siliconerubber.com
TYPICAL PROPERTIES FOR SILICONE RUBBER
 

Typical Properties

Molding & Extrusion Grade, Heat Cured Rubber - Peroxide Cure

POST CURED 4 h/200ºC

 GENERAL PURPOSE HIGHER STRENGTH
Appearance Transparent Transparent Transparent Transparent Transparent Transparent Transparent
Specific 1.12 1.15 1.19 1.10 1.16 1.17 1.19
Hardness, Shore A 40 60 80 30 50 60 70
Tensile, Mpa (psi) 10.0
(1449) 		10.4
(1505) 		9.6
(1390) 		9.3
(1350) 		10.0
(1450) 		11.0
(1590) 		10.0
(1450)
Elongation, % 570 470 350 875 700 650 500
Tear, Die B, kN/m (ppi) 22
(125) 		21
(120) 		21
(120) 		26
(150) 		35
(200) 		35
(200) 		35
(200)
Compression Set, % 22 h/175ºC 20 35 55 20 20 25 25
Volume Resistivity N/A N/A N/A N/A N/A N/A N/A
USP XXIII, Class VI Passed Passed Passed Passed Passed Passed Passed
Characterisitics Uncatalyzed, General Purpose


(1) Typical property values are not intended for use in the preparation of specifications. Please contact SRRP for assistance and recommendations before writing specificstions on these products.

(2) Custom formulations are available if certain properties must exhibit higher values than those shown above. This chart is intended to be used for illustrative purposes only.
Silicone Rubber Right Products, LLC
112 West Lake Street, Northlake, IL 60164       Phone: (708) 531-1717     Fax: (708) 531-1719